Hazard Identification and Evaluation Before beginning the hazard evaluation and risk assessment process, a researcher must define the scope of work. For large abrasive blasting or spray painting jobs where there may be a higher level of hazards, a Team Based Risk Assessment may be required. Hazard and Risk Identification The hazard identification process should be used for routine and non-routine activities as well as new processes, changes in operation, products or services as applicable. • Guidelines for Hazard Identification, Risk Assessment and Risk Control • Department of Occupational Safety and Health Ministry of Human Resources Malaysia 2008 JKKP DP 127/789/4-47 ISBN 978-983-2014-62-1 for Hazard Identification, Risk Assessment and Risk Control ( HIRARC) Guidelines All of the topics covered in this checklist may not apply to your particular workplace. for STOP and Job Safety Analysis Risk Assessment (CSBP-GM-11-031-23) for details. 3.3 Risk Identification and Assessment Assessment Info: There are some measurement tools to indicate the risk for dermatitis in this task, where skin contact with paint-solvents is common, that include observation to see how frequent skin contact occurs and asking workers about skin symptoms. The following terms have been used for the risk assessment. The Safety Manager shall conduct a baseline worksite hazard assessment which … The following checklist can be used to identify and evaluate hazards in your workplace. 3.4 WORK PERMITS Team members can include others up to six persons if needed. PAINTING JOB HAZARD ASSESSMENT 1 Job Hazard Hazard Control Trip or fall hazards Walking/working surfaces training for working around uneven, wet and slippery surfaces (includes warning to others of slippery surfaces); use cord cover and out of traffic areas Hazard identification and evaluation, hazard controls, roles and responsibilities, and general chemical safety are all important parts of this assessment. During the hazard identification and risk assessment the presence of occupational health stresses and safety factors were considered. Consequence The potential degree of harm, potential severity of injuries and/or health; and/or the number of people potentially affected. HAZARD ASSESSMENT CHECKLIST. This checklist covers a wide variety of workplace safety and health hazards. Refer to CSBP Guide Manual Team Based Risk Assessment (CSBP-GM-11-030-02) for details. Risk assessment team identifies the hazards using hazard identification, Risk assessment and observation record sheet form (HSE-HI/FR01) which reviewed by the process owner manager and approved by HSSE Manager.