I used a hammer drill to drill the hole in the bowl. Let the compound harden overnight. Apply lots of hot glue over the flange and around it to lock the flange in place and plug all the holes watertight (the tape prevents the glue from dripping through holes). The tubing I used fit snugly into a 3/4-in. Mark out the form parts and cut the tapered parts (A and C) with a circular saw using a standard wood-cutting saw blade. Do Not Sell My Personal Information – CA Residents, 20-minute setting-type joint compound (1 bag), Four 10-oz. You’ll get better results if you’re working comfortably, and you’ll save your back. Cut the mesh into 9-1/2-in. Clean the fountain, including the water … Hardness and grain aren’t always obvious from look and touch. It's OK if the mix is a bit lumpy. Soothing Water Fountain. You won’t need any special talent, just a few tricks and a couple of diamond saw blades (see “Tools and gear” below). Break out the slivers of stone to open up the channel. Fast & Free shipping on many items! If you guesstimate where the line is and guess wrong, you’ll end up with a lopsided bowl. You'll use these anchors later to tie the column and basin together. During those hot summer days,… To smooth the bowl, you’ll need a small angle grinder and a grinding wheel. Good to Know. Then they said that the material was going to be concrete, and I started an inner, mini-freak out. Leave the legs of each anchor protruding 3/4 in. If you buy stone, be sure to ask for recommendations. of joint compound. We filled the recess at the top of the column with smooth black “river pebbles. bottle of Quikrete Cement Color per 80-lb. Or check out this other DIY low-maintenance water feature. Fill the sphere form first, before the mix begins to stiffen. Sketch the channel with a pencil and then darken the lines with a marker. deep, switch the hammer action on for faster drilling. Molds to Make Yard Fountains. ( : This instructable is on behalf of Madeline Werner, the caster of these lovely leaves. A concrete pond adds beauty and functionality to your landscape. You have to adjust the flow from the pump, level and shim the stone from side to side so water doesn’t spill out of the bowl, and tilt the stone slightly for a strong, spilling stream. It is self contained so you don’t need to do much except plug in the pump! To remove the sphere form, just break it away. In cold climates, disassemble the fountain and remove all of the water before storing it. I wanted to make a leaf embossed concrete fountain that the birds could enjoy too. The fountain loses water because of splashing and evaporation, so keep an eye on the water level whenever you run the pump. to hide the liner. Here is some junk inspired water features for your yard! Take five minutes to set up a sturdy work surface (I used a couple of sawhorses and 2×8 planks.) ”. With very soft stone, like the sandstone I used, you can polish the bowl even smoother by hand-sanding with 80-grit sandpaper. Those flying slivers of stone sting. Cover the holes in the flowerpot with duct tape. If you want a curving channel like ours, avoid tight curves; anything tighter than the curve of a 1-gallon paint can will be tough to cut with your grinder. A weekend is plenty of time to carve the stone and create a small pond. Basin footprint: 20 x 20 in. If the water spills down one side of the column but not the others, slip a flat pry bar under that side of the basin. If you press too hard or hesitate, you’ll create gouges that require more grinding to smooth over. After that, you’ll have space to aim your chisel at the base of each slice, and most will pop out with one blow. Here are some tips for a smooth project: Make plunge cuts across the bowl outline. diamond blade. We are no longer supporting IE (Internet Explorer) as we strive to provide site experiences for browsers that support new web standards and security practices. Slather margarine onto a small rag and coat the inside of the form so the concrete won't stick to it.